A/D convertor calibration of the DSP unit starts and it takes 10 sec.While pushing and, push to turn power ON. Here is how is instructions directly from the Icom manual: Resetting CLEARS all programmed contents in memory channels and returns programmed values in set mode to default values. If it doesn't work you can come back and reset at a later time and start over. You will lose all your memories in this process so you are welcome to try all the setting without resetting the radio first. 1.It is always best to reset you radio to the factory setting just in case you have made some setting that may interfere with the operation of the RigPi. The Mic jack on the front of the radio is controlled by the volume control giving more flexibility.
Be aware that the audio out is fixed and while there are adjustments in the RigPi for the audio it still may not get you what you need. Here is the link to what you need to order: You can probably get the audio from one of the 8 pin ACC1 jack in the rear of the radio but I have not tested this so you are on your own. It is suppose to come with the cable but some old stock in the stores are missing the cable. I recommend buying the cable directly from MFJ and make sure they include the Jumper cable that you will need. You will need to unplug the mic and plug in this cable when using the RigPi. I have chosen to use the cable that goes from the RJ45 on the audio card to the Mic connector on the front of the radio. You will also need an audio cable to connect the transmit and receive audio from the radio to the RigPi. The one I tested was from Amazon and here is the link: You will need to buy a CI-V to USB cable. The CAT control will be controlled from the 1/8 inch plug CI-V port in the back of the radio. This radio does not have a USB plug for CAT control or audio.
Please compare the menu settings to the ones I have provided here for the ProIII. Icom 756pro and IC-756proIII radio setup (the set up for the Icom 756pro and 756proIII are the same) Introduction - Whiles these instructions were developed from the Icom 756proIII manual they should work for all Icom 756xxx radios. NOTE: If you install the new audio file per Howard's instructions you will need to use the new overlay as the default system selection in mumble since you are using the audio card.
0 kommentar(er)
